关于
全部信用评价 (371)
-
azdome_official_us (5088) - 买家留下的信用评价。超过 1 年购买已获认证Good buyer, prompt payment, valued customer, highly recommended.
-
ds-auto-parts (11817) - 买家留下的信用评价。超过 1 年购买已获认证Quick response and fast payment. Perfect! THANKS!!
-
buyithere_18 (4036) - 买家留下的信用评价。超过 1 年购买已获认证Hope to deal with you again. Thank you.
-
carid (341449) - 买家留下的信用评价。过去 1 个月购买已获认证Hope to deal with you again. Thank you.
-
***** - 买家留下的信用评价。过去 6 个月购买已获认证Quick response and fast payment. Perfect! THANKS!!
-
koskowski_automotive_llc (58163) - 买家留下的信用评价。去年购买已获认证Good buyer. Come back soon to Koskowski Automotive, LLC
评价
(14)
2020 年 01 月 01 日
Much larger than I needed.
I only wish it came in more sizes. Only sizes I had a choice from were car/SUV or big truck. I got the smaller of the two and it still is bigger than I needed. It not only covers the entire windshield, it also covers half the hood and a foot of the roof of my Subaru Forester. It’s so large, even with the fasteners, the wind blows the snow up and under it. I bought three of them. The other two are for my other Subaru and a Silverado pickup. Even to big for the Chevy. Great frost shield though.
2017 年 01 月 04 日
Won't stay flat
I purchased these oval rugs so I would not need to deal with corners lifting up, as so may square and rectangular rugs do. These were rolled so tight for shipping, I cannot get them to lay flat. I tried stretching and taping them down tight for a week, steaming the backing with an iron, with no luck. I ended up putting double sided tape along the bottom, about every foot or so, to hold it down and flat. Unfortunately, this requires re-taping every time I need to move it for floor sweeping. A burdensome task.
2016 年 11 月 23 日
Good product for the money, I guess.
在 1 位用户中，有 1 位用户认为此评价有帮助
They say you get what you pay for. This is no exception. It was low cost and it shows. Although it works as stated in the listing, it seems a bit under powered. It needs higher RPMs to keep doing the job. Any excessive force at all, and the wheel stops. Easily gets jammed, if just a little to much force is used and the link vise is not up to holding the cutter link securely in place while the wheel is lowered, if done so too forcefully. You have to to it slow and easy, with gentle movements. It does sharpen the chain very well, but takes a little getting used to and you cannot rush it.