关于
全部信用评价 (703)
-
gesaenterprises (6679) - 买家留下的信用评价。过去 1 个月购买已获认证Quick response and fast payment. Perfect! THANKS!!
-
yoyocheckout (16251) - 买家留下的信用评价。过去 6 个月购买已获认证Quick response and fast payment. Perfect! THANKS!!
-
radio-top (11303) - 买家留下的信用评价。过去 6 个月购买已获认证Quick response and fast payment. Perfect! THANKS!!
-
wishcolors (400) - 买家留下的信用评价。过去 6 个月购买已获认证Great communication. A pleasure to do business with.
-
reglove_0 (25) - 买家留下的信用评价。过去 6 个月购买已获认证Great buyer...would do business again
-
eeekitonline (480795) - 买家留下的信用评价。过去 6 个月购买已获认证Hope to deal with you again. Thank you.
评价
(16)
2019 年 07 月 02 日
Fits well on US spec G35, only needs minor clearance.
Good fit on my LHD US Infiniti G35 Sedan (with automatic). I do have solid delrin motor mounts but it was easy to get in and out and bolted straight up with no modifications to the head bolt holes. It was a snug fit for the rear most but on the driver's side flange but if you start it by hand first it was easy to tighten by hand and finish with an open end 14mm wrench. The drivers side just barely cleared the steering shaft but I dimpled it with a ball peen hammer and torch for just a bit more clearance. The bolts and gaskets included are adequate but you can do better. I had bought a similar header with a bigger diameter collector which had a warped flange that was not sealing well and some of the bolt holes did not line up well and they were too snug. Even if modified the steering shaft wanted to go a full shaft diameter inside the edge of one of the tubes. Performance seems good and tuner has no complaint of leaks. Very happy and much better than the last set I tried.
2016 年 11 月 16 日
Makes an old car feel like new again.
I just recovered the front seats and couldn't stand to put the old wadded up mats back in. These OEM floor mats are an absolutely perfect fit and exact replica of what I originally had, just with all the rubber backing still attached. It still has the same velcro tabs attached to the rubber which I know will fail in about 9 or so years, but it also includes the newer plastic pokey bit tabs with velcro that require you make a hole in the mat and then will add an extra velcro attachment point that will use the whole of the carpet pad to keep it in place and should extend the life much further. I chose not to install the new part to avoid cutting a hole in a brand new mat but I will keep them for when it starts showing wear in a few years so I can extend the life further. I wish now I had replaced these years ago, much better than generic mats that don't fit at all or spending as much or more for mats that aren't a perfect OEM fit. Definitely the way to go if you have the choice.
2019 年 07 月 30 日
Fits better than expected, easy to install, good paint match.
Paint is nice and glossy with no flaws and seems to be a very good match to the OEM black, nothing will be perfect for 7 or 8 year old paint but it looks good. Only time will tell the quality of the paint and prep but it's a huge improvement over the heat warped original GM piece. It fit pretty well replacing an OEM parts but it's not perfect (neither was the original) but it fits good enough and I think only I will notice. Mine overhangs the back just a little more than the original. It mounts with bolts and washers instead of studs with a flange nut as the original, but it's easier to install that way, as the bolts have Phillips heads as well as hex so o used a magnetic screwdriver to place them and a 10mm socket to tighten them with much less chance of losing them inside the trunk lid. If you are removing the nuts on an existing one use a nut driver and just before the at off close the trunk as much as you can so it's easier to get them out without dropping them, unless you have something with a magnetic in it to keep them in the socket. I can't say how useful the alignment plastic bits are for drilling holes if it's a new install but I don't envy anyone attempting that install.